This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
syntax [2015/05/01 11:27] curlymo created |
syntax [2015/11/27 22:09] (current) |
||
---|---|---|---|
Line 185: | Line 185: | ||
</code> | </code> | ||
- | Of course, the maximum dimlevels can still be overriden by the KlikAanKlikUit remote, but pilight will make sure it cannot control the dimmers below or above these dimlevels within pilight. | + | Of course, the maximum dimlevels can still be overridden by the KlikAanKlikUit remote, but pilight will make sure it cannot control the dimmers below or above these dimlevels within pilight. |
===== Rules ===== | ===== Rules ===== | ||
Line 298: | Line 298: | ||
=== send-repeats and receive-repeats === | === send-repeats and receive-repeats === | ||
- | The send-repeats setting will define how many times pilight must repeatedly send a code. This can depend on your environment. If you have a clear view between your Raspberry Pi and the devices you want to switch, then this number can be lower. When your Raspberry Pi is in a environment with a lot of interference this number needs to be higher. | + | The send-repeats setting will define how many times pilight must repeatedly send a code. This can depend on your environment. If you have a clear view between your Raspberry Pi and the devices you want to switch, then this number can be lower. When your Raspberry Pi is in an environment with a lot of interference this number needs to be higher. |
''Support for send-repeats ends with pilight V6 and is replaced with individual protocol settings.'' | ''Support for send-repeats ends with pilight V6 and is replaced with individual protocol settings.'' | ||
Line 357: | Line 357: | ||
In case the computer that the pilight-daemon is running on does not have GPIO capabilities, choose this option. | In case the computer that the pilight-daemon is running on does not have GPIO capabilities, choose this option. | ||
- | ==== 433.92Mhz ==== | + | ==== 433.92 MHz ==== |
=== lirc_rpi Kernel Module === | === lirc_rpi Kernel Module === | ||