User Tools

Site Tools


praw

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
praw [2015/06/26 05:18]
troccolo corrected µS to µs
praw [2016/12/06 13:17]
andies Added notes below about noise suppression.
Line 42: Line 42:
 //​**NOTES:​**//​ //​**NOTES:​**//​
  
-//If you use non approved receiver modules and no Low Pass Filter (LPF), pilight picks up a lot of noise. See wiki for recommended [[receivers]] and forum for information about [[http://​forum.pilight.org/​Thread-Europe-Only-Band-pass-filter-parts|hardware filter]]//+//If you use non approved receiver modules and no Low Pass Filter (LPF), pilight picks up a lot of noise. See wiki for recommended [[receivers]] and forum for information about [[http://​forum.pilight.org/​Thread-Europe-Only-Band-pass-filter-parts|hardware filter]] ​But notice: 433 MHz transmission is based on OOK (ON-OFF-Keying) of a 433 MHz RF-carrier, the result is a square signal with sharp rising/​falling edges. One can only suppress rising/​falling edges based on the knowledge that the minimum distance between rising/​falling edges is approximately 100µS and simply ignore transitions with shorter durations.//
praw.txt · Last modified: 2016/12/06 13:17 by andies