User Tools

Site Tools


pdebug

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
pdebug [2016/12/11 12:03]
andies I added some remarks about pulse, pulselen, rawlen etc. Is there an older version of debug shown?
pdebug [2016/12/20 18:28] (current)
andies
Line 18: Line 18:
 </​code>​ </​code>​
  
-Any single number measures the time difference between a HIGH-LOW or LOW-HIGH transition (for example, it took 286 microsec from the first measured HL to the next LH). There are 132 of that numbers in the debugged code, therefore rawLength or rawlen is 132. The last transition is called footer (also pulselen) and usually pulselen*34 is reported as the last number in this long list. pulse is an important multiple of pulselen that submits the signal (often the maximum of pulslen'​s in the long list above).+<​ToDo:>​What is footer and what is header? What is footer? How is binary code evaluated or determined from pulse/pulse train/pulse length?</​ToDo:>​ 
 + 
 +Any single number measures the time difference between a HIGH-LOW or LOW-HIGH transition (for example, it took 286 microsec from the first measured HL to the next LH). There are 132 of that numbers in the debugged code, therefore rawLength or rawlen is 132. The last transition is called footer (also pulselen) and usually pulselen*34 is reported as the last number in this long list. <​ToDo:>​ What is pulse?</​ToDo>​.
  
 You can now use the raw code to control your device: You can now use the raw code to control your device:
pdebug.1481457821.txt.gz · Last modified: 2016/12/11 12:03 by andies