User Tools

Site Tools



This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
none [2014/01/26 22:12]
curlymo created
none [2015/11/27 21:09] (current)
Line 1: Line 1:
 **None** **None**
 +This module is meant to disable the sending and receiving functions of pilight. This can especially be handy when you run pilight on a system without GPIO capabilities such as a FreeBSD NAS or Ubuntu desktop.
 ^Feature^Support^ ^Feature^Support^
Line 10: Line 12:
 Config Config
 <​code>​ <​code>​
- "433lirc": { + "none": { }
- "​socket":​ "/​dev/​lirc0"​ +
- }+
 </​code>​ </​code>​
 Arguments Arguments
-  * socket: on what socket file is the lirc_rpi module registered 
-Extra +//None//
- +
-Make sure you have the lirc_rpi properly loaded. This can be done like this: +
-<​code>​ +
-sudo modprobe lirc_rpi gpio_in_pin=17 gpio_out_pin=18 +
-</code> +
-The lirc_rpi uses the BCM GPIO numbering. +
- +
-Be aware that the lirc_rpi module can only be used by one single program. So you can't use both Lirc and pilight. If you do want to use both, you can use XBian. This distribution has an additional copy of the lirc_rpi module called lirc_rp1. +
- +
-To load the lirc_rpi module on start-up, you can add it to the /etc/modules file: +
-<​code>​ +
-/etc/​modules:​ kernel modules to load at boot time. +
-# This file contains the names of kernel modules that should be loaded +
-# at boot time, one per line. Lines beginning with "#"​ are ignored. +
-# Parameters can be specified after the module name. +
- +
-lirc_rpi gpio_in_pin=17 gpio_out_pin=18 +
none.1390774322.txt.gz · Last modified: 2015/11/27 21:08 (external edit)