User Tools

Site Tools


ds18s20_v6_0

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
ds18s20_v6_0 [2015/01/27 19:05]
curlymo
ds18s20_v6_0 [2015/02/11 14:02]
curlymo
Line 48: Line 48:
  
 ==== Notes ==== ==== Notes ====
- 
 Before pilight can see the sensor, you have to run the following commands: Before pilight can see the sensor, you have to run the following commands:
 <​code>​ <​code>​
Line 60: Line 59:
 w1-therm w1-therm
 </​code>​ </​code>​
 +
 +If you have enabled "​Device tree support"​ (since Raspbian with kernel 3.18 it's the default configuration),​ you have to add the following line to ''/​boot/​config.txt'':​
 +<​code>​
 +dtoverlay=w1-gpio-pullup,​gpiopin=4
 +</​code>​
 +This will load the module w1-gpio, so you only have to add ''​w1-therm''​ to your ''/​etc/​modules''​.
 +
  
 To find the correct sensor id, you have to run the following commands: To find the correct sensor id, you have to run the following commands:
ds18s20_v6_0.txt ยท Last modified: 2015/11/27 21:09 (external edit)