User Tools

Site Tools


ds18b20

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
ds18b20 [2013/10/21 19:06]
koffie
ds18b20 [2015/11/27 21:09] (current)
Line 6: Line 6:
 |Config|{{http://​wiki.pilight.org/​lib/​images/​supported.gif}}| |Config|{{http://​wiki.pilight.org/​lib/​images/​supported.gif}}|
  
-Supported Brands+==== Supported Brands ​====
 ^Brand^Protocol^ ^Brand^Protocol^
 |1-Wire|ds18b20| |1-Wire|ds18b20|
  
-Supported Brands +==== Sender Arguments ​====
- +
-Sender Arguments+
  
 //None// //None//
  
-Config+==== Config ​====
 <​code>​ <​code>​
         "​living":​ {         "​living":​ {
Line 31: Line 29:
 </​code>​ </​code>​
  
-Optional Settings+==== Optional Settings ​====
  
 ^Setting^Default^Format^Description^ ^Setting^Default^Format^Description^
-|decimals|3|number|How many decimals does the temperature information contain| +|device-decimals|3|number|How many decimals does the temperature information contain| 
-|humidity|0|1 or 0|Don'​t display the humidity ​value| +|gui-show-temperature|1|1 or 0|Don'​t display the temperature ​value| 
-|temperature|1|1 or 0|Don't display ​the temperature value+|poll-interval|5|seconds|What should be the poll interval of the sensors
-|battery|0|1 or 0|Don't display the battery ​value|+|device-temperature-offset|0|number|Correct temperature ​value|
  
-Protocol+==== Protocol ​====
  
 //None// //None//
  
-Note:+==== Notes ==== 
 Before pilight can see the sensor, you have to run the following commands: Before pilight can see the sensor, you have to run the following commands:
 <​code>​ <​code>​
Line 50: Line 49:
 </​code>​ </​code>​
  
-To make sure this is done every reboot, edit the /​etc/​modules ​file and add the following ​text:+To make sure this is done every reboot, edit ''​/​etc/​modules'' ​and add the following ​lines:
 <​code>​ <​code>​
 w1-gpio w1-gpio
 w1-therm w1-therm
 </​code>​ </​code>​
 +
 +To find the correct sensor id, you have to run the following commands:
 +<​code>​
 +cd /​sys/​bus/​w1/​devices
 +ls
 +</​code>​
 +
 +The result will look like:
 +<​code>​
 +28-0000055bd776 ​ w1_bus_master1
 +</​code>​
 +
 +Use the part after 28- as the correct id, e.g. 0000055bd776.
ds18b20.1382382391.txt.gz · Last modified: 2015/11/27 21:08 (external edit)